● With the popular of DCS system, the traditional function of dual table can realize by DCS system、DCS system only need a 4〜20mA signal input. MJ-VR9200A Series 4-20 mA Low Cost Velocity Sensors can meet these requirements、it has superior performance like small size, light weight, reliable performance.

● MJ-VR9200A lntegrated magnetic vibration transducer operate by magnetic-electric dipole movement of magnetic field lines cut principle, thus transfer the voltage signal amplitude to standard current signal.Signal output has wrong line protection function, it can avoid transmitter be damaged due to wrong line on site.

インストール

● Installation position: vertical or horizontal vibration in the measured point, the sensor screws in the bottom of the test case, and then the sensor tighten screw on top.

● Installation dimensions and specifications: If the transmitter is mounted flush position when subjected to high temperature steam, in order to reduce the ambient temperature transmitters, need to add protective measures, under normal circumstances do not add protection.

● Wiring Instructions: Brown wire connected to the positive terminal of the power DC24V, DC24V power blue wires connected to the negative side, both brown and blue wires is 4 ~ 20mA output leads. Connecting wires require good insulation properties, using standard GB 0.5MM2 two core shielded cable.

For example: MJ-VR9200A-C-10V-01-02-00K-00

Meaning measuring vertical speed value、measuring range is 0-10mm/s、Mounting screw thread M10 ×1.5、cable 2m、Directly lead and armored. Frequency response 10-1000Hz (unidirection / universal )