● به طور عمده در اندازه گیری زمان واقعی آنلاین از لرزش شعاعی شافت روتور ماشین های دوار استفاده می شود. قطر شافت خروجی تا لرزش. تشخیص زودهنگام ، زنگ خطر و محافظت از ماشینهای دوار ، به طوری که طول عمر دستگاه دستگاه افزایش یافته و واحد چرخه نگهداری کوتاه شده است.

● High level of integration, no proximitor, high reliability

● MJ-VR9820 integrated the function of proximitor and the transmitter .MJ-VR9820 only need probe and extension cables. As MJ-VR9820 save the proximitor, making monitoring assembly further reduced, so the reliability is greatly improved.

● Install easily without any adjustment

● MJ-VR9820 is extremely easy to install, can be installed in the field or in the control room. The machine measured point: General requirements in the vicinity of the bearing installation of a X, Y two intervals of 90 ° MJ-VR9820 transmitter. For a standard double bearing rotating machinery, usually installed 4 sets of vibration transmitter. The parameters have been adjusted and calibrated in our factory. So customer just need to connect the right cables without any adjustments and calibration. MJ-VR9820 can connect with our company's 8mm eddy current sensor probe .

● Gap of eddy current sensor: Generally adjust GAP output to 10 ± 0.25V.

● Fault Monitoring: Monitoring of rotating machinery rotor shaft radial vibration.

● Measurement parameters: Radial vibration (displacement) of the peak to peak.

● Unit Type: Variety of sliding bearings of rotating machinery. Such as steam turbines, fans, compressors, motors, pumps and so on.

●Installation Requirements: MJ-VR9820 directly connect with the eddy current probe, extension cable.

Transmitter Dimension:

MJ-VR9820 vibration transmitter deal with the signal of peak to peak vibration displacement via the transmitter filter, peak to peak detection and normalization. Directly output 4-20mA signal to DCS, PLC interface for rotating machinery rotor shaft vibration monitoring. It provides a simple, low-cost way.

● Conditioning monitor:

Monitoring a rotor radial vibration, including shaft vibration and rotor swing etc..

● Measurements:

Measures unbalance, asymmetric, and loosen parts resulted in high vibration.

● Typical application:

Widely applied to vibration monitor of various rotary machines such as turbine, fan, compressor, motor and pump etc.

● Installation:

Need an additional eddy current proximity probe and an extension cable to build a measuring system, and the system should be installed on safety site.

MJ-VR9820 -A□□-B□□-C□□-D□□-E□□-F□□-G□□-H□□-I□□